The Process of Installing Face Basin Taps

Faucets should be familiar to all of us. Faucets are everywhere in our lives, and there are many faucets used in our homes. The use of the face basin taps is indispensable in our lives, so how to replace the face basin taps if there is a problem?

1. Tips for installing face basin taps

When installing a single-handle face basin tap, a special angle valve must be selected, and the angle valve must be fixed with the hot and cold water pipes of the wall. If the water inlet pipe is too long and exceeds the water outlet pipe, you can cut off the part according to your needs. If the angle is not suitable, you can bend it to the position you need according to your needs. Remember: Do not bend hard to 90 degrees or more. When installing the basin to drain, please don't forget to buy the small interface of the faucet (the faucet is shorted). Don't forget to flush the pipes buried in the wall before you install.

Before installing the thermostatic faucet, please check whether the water pipes are hot on the left and cold on the right. Remember not to connect the hot and cold water pipes wrongly, so as to avoid the faucet not working properly. Gas and solar water heaters cannot use thermostatic faucets because the water pressure is too low. Please do not forget to install the hot and cold water filter when installing the thermostatic faucet.

2. The installation process of face basin taps

Step 1: Take out the face basin taps and check whether all accessories are complete. For competitive bathroom accessories sale from Likegro. Before installation, be sure to remove the dirt around the installation hole and in the water supply pipeline to ensure that there is no impurities in the water inlet pipeline of the face basin taps. To protect the surface of the faucet from scratches, it is recommended to wear gloves for installation. Step 2: Take out the rubber gasket of the face basin taps, the gasket is used to relieve the pressure of the metal surface of the faucet in contact with the ceramic basin, to protect the ceramic basin, and then insert a water inlet pipe and tighten it.

Step 3: Put the threaded joint into the first water inlet hose, and then put the water inlet end of the second water inlet hose through the threaded joint.

Step 4: Screw the second water inlet hose into the water inlet port, pay attention to the correct direction, use a balanced force, and then tighten the threaded joint.

Step 5: Thread the two water inlet hoses into the white rubber pad.

Step 6: Put on the lock nut to secure the face basin taps.

Step 7: Then tighten the sleeve.

Step 8: Tighten the two inlet pipes and the angle valve interface respectively. Do not use the pipe wrench to fully twist it to prevent deformation or even breakage. Pay attention to the connection of hot and cold water. Connect the water outlet angle valve with the other end of the water inlet pipe.